Product Search
Search results for 'D6927'
Showing 61 - 80 of 1122 Total Results
CA-0500-43
Location: Air Meter Calibrators
Aluminum Air Meter Calibrator quickly checks the accuracy of any pressure-type concrete air meter with a .25 cu. ft. base - from Test Mark Industries.
Density Drive Sampler, 3" ( 76.2 mm)
SA-1355
Location: Density Drive Sampler
The density drive sampler from Test Mark determines in-place density of soil by driving a thin-walled tube into the soil mass to obtain a relatively undisturbed sample. 3" model.
Density Drive Sampler, 4" (101.6 mm)
SA-1360
Location: Density Drive Sampler
The density drive sampler from Test Mark determines in-place density of soil by driving a thin-walled tube into the soil mass to obtain a relatively undisturbed sample. 4" model.
Perpendicular Verification Device
(3) options
Location: Perpendicular Verification Device
The Perpendicular Verification Device is used to verify the alignment of 6" x 12" and 4" x 8" concrete cylinders when using un-bonded caps, as required by ASTM C-39. The device rests on the lower platen of the compression machine, avoiding contact with your retainer rings. Simply center the...
(5) options
Location: Shelby Tubes
Shelby Tubes from Test mark feature a chamfered end that forms a cutting edge, and includes holes for securing tubes to a drive head.
Non-Mercury Min/Max Thermometer
CA-0790-A
Location: Min/Max Thermometers
Mercury free, environmental friendly spirit filled thermometer. This dual-scale min/max thermometer has U-shaped capillary mounted in a rugged plastic case with eye hole for wall mounting. Indicates present temperature and the highest/lowest temperature since last reset.
CA-0500
Location: Air Entrainment/Pressure Meter
The air entrainment concrete pressure meter from Test Mark is part of a complete line of concrete testing equipment, available for easy online ordering.
CA-2980-03
Location: Aggregate
Chart has five permanent reference colors mounted in a durable protective plastic case.
Dynamic Cone Penetrometer with Auger
SA-1200
Location: Dynamic Cone Penetrometer
Test Mark's Dynamic Cone Penetrometer (DCP) uses a 15 lb. steel mass that falls 20 inches and can be used effectively in augered holes to depths of 15 to 20 feet.
Spacers for CM-4000 and CM-5000 Series
(2) options
Location: Spacers
Spacer Assembly for Compresson Machines is used to adjust the inside vertical testing height of the compression machine load frame for testing samples of various heights.
(7) options
Location: Graduated Cylinders, Plastic
Polypropylene graduated cylinders from Test Mark have a single scale with raised numerals for easy reading.
CA-0285
Location: Cube Molds
The Econ-O-Cube mold from Test Mark forms three 2-inch cubes at one time in a diagonal arrangement. Easy and secure online ordering.
CA-2710
Location: Specific Gravity & Absorption Fine Aggregates
Test Mark's pycnometer is used to determine specific gravity of fine aggregates. Easy online ordering.
Spacers for CM-0030 and CM-2500 series
(4) options
Location: Spacers
Spacers are used with test platens to adjust the vertical working clearance height inside a machines load frame, for testing samples of various types and sizes to prevent over-extension of the load frames piston. They are manufactured from steel and machined plane on both ends to maintain a...
Curing Rack, 4" x 8" Cylinders 6/ctn
CA-0218
Location: Parts & Accessories
These durable racks are manufactured from plastic compounds and recycled materials to resist moisture, abrasion, chemical and temperature variations. Each rack has built-in handles, making them easy to carry and safely stacked 12 tiers (58") high. The racks unique open frame design allows water...
